User`s manual

7.2.2 Iris, Focus, Zoom Control
Move the cursor to the desired control button
and hold the mouse on left button to perform the
desired operation. When the button is released, the
operation also stops. The circles to right of Iris and
Focus are used to activate “auto-iris” and “auto-focus”
control. Some dome cameras may not support
these functions. Users need to check with
vendors in advance.
7.2.3 Preset point function and its setup.
Only dome cameras support the Preset function. Click
the Preset button on the PTZ control panel, the
camera will fast move to the preset point. According
to the type of dome camera, a maximum of 32 preset
points can be set. To set the preset points, move the
camera to the desired position, and click the
button on the PTZ control panel to finish preset point
setup.
The way to set PIH717X is slightly different. For
example, to set the third preset point, you should first
click the button of the third preset point on the PTZ
control panel, then move the camera to the original
third preset point first, and use the direction, focus
and Zoom buttons to move the camera to the new preset point; last,
click the
button on the PTZ control panel to preset.
7.2.4 Auto Pan Function and setup
Only dome cameras support auto-pan function,
allowing camera to fast and horizontally move
between two points. Click
button to the
right of Auto button on the PTZ control panel to
pop up the dialog to enter the setting. Specify
the preset start/stop points and the camera pan
speed. Click OK button to complete the setup.
Auto-pan moves cameras horizontally between the preset start point and
the preset stop point rather than simply from the preset start point to the
preset stop point. Some dome cameras may not support this Auto-pan
function. Users need to check with vendors in advance.
7.2.5 The Cruise Function And Setup
71