User`s manual

- Play Alarm Sound: Select this option and click Select, the sound

selection dialog will pop up. Select the wanted sound file and click

OK. The sound file name will appear on the playback column to

finish the sound selection.

- Activate Local Site Recording and Remote Alarm: Select

camera number, the Input trigger alarm camera setting will pop

up.

 Start Recording: If select active recording and the assigned

camera are set for remote alarm, this function will activate

remote alarm function. The duration of recording will be the

time defined in alarm duration of Alarm Setup.

 Trigger to preset: A dome camera can fast turn the camera to

a preset point upon triggering by an input signal. Setup: Select

the trigger to preset function and set the trigger preset, (Note:

Make sure that the respective settings of PTZ device are made

during the camera setup) Dwell time and Back preset.

- Enable Output Port: This may drive the output devices to output

signals. Click Setup, the Alarm output control panel dialog will pop

up to select desired output device’s group and output points.

7.2 PTZ Control Panel

Click button from the panel to display the control panel. Click

button already shown on the panel to open PTZ control panel like the left.

Please refer to Chapter 4.3.4 PTZ control select for more detail. A remote

connected user with the authorization to control remote I/O device can

also remote control the PTZ devices from this control panel.

7.2.1 Direction Control

PTZ control panel provides 8-direction control. Move the cursor to the

button for desired direction and hold the left button of the mouse to

perform the desired turn. When the button is released, the turn also

stops. Some dome cameras may support only 4 directions, i.e.

Up/down, right/left. Users please check with us in advance.