User`s manual

7.1.4 Editing I/O Device
Click on the device to be edited the Editing I/O device dialog will pop
up for editing.
7.1.5 Setting up I/O Device
Double click the desired device to pop up the I/O Device setting
dialog.
7.1.5.1 Watchdog Function
Only VGIO provides with watchdog
function. The reset signal of PC main
board shall be connected to the JP2 (1,
2) of VGuard card and the JP2 (3, 4) of
VGuard card be connected to the reset
switch of the front panel, so that the PC
main board will have the reset function.
If the computer, activated with Chateau
program, crashed, the computer will re
boot after 6.5 minutes.
7.1.5.2 Output Port Signal Type Setup
Select output port number, the Output Port setup dialog will pop up.
- Output Port Name: Setup Output port name.
- For PTZ Control: Enable it for PTZ control. Then select which
PTZ control for this output port, include up, down, left, right, zoom
in and zoom out etc.
- Port Type:
 Signal 1: Low to high (Off to On). Defaulted.
 Signal 2: High to low (On to Off).
68