User`s manual

Snapshot pictures will be saved under Picture directory on the

alarm date.

Select this option and you can enter the continuously snapshot

number and picture number.

Note: Enable this functions might share lots of hard disk spaces.

Please be aware.

 Remote Alarm: After activated of this function, Chateau System

will be able to send alarmed messages to remote site. If not

activated, remote site will not be able to receive any alarmed

messages. Please refer to

Chapter 6.2 Setup for receiving DVR

remote warning for more information.

 Active the output device: This is local alarm. Enable this option,

Chateau system can control the local site output device when

alarm triggered. Ex. Alarm bells, switch gear.

Select this option, click the setup button and the Setting Output

control panel dialog will pop up for setting the output device.

Please refer to

Chapter 7: I/O Device for more information.

6.2 Setup for receiving DVR remote warning

To receive the remote warning, you will require a certain setting on the

Chateau Host.

Firstly you will need to connect the alarm source PC DVR or alarm source

embedded DVR with the system receiving the remote warning. On the

receiving warning Chateau System, double click the left button of the

mouse on the host list and switch the remote images to the alarm source

PC DVR or alarm source embedded DVR. Click Setup button into the

Board and Camera pages, into the Camera pages. Activate the certain

alarm setting and enter the alarm setup dialogue as below.

 Activate by Schedule Table: Receiving the warning or not from DVR

can depends on the set schedule. Please refer to

Chapter 6.1.2

Activate condition for more information.

 Play Warning Sound: Activate this function, when the alarm source

system alarmed, Chateau system will play the selected sound file.