User`s manual

The detection area in the photo on the
left is shown in blue color, to mean that
alarms are triggered but Enable Alarms
of the Alarm Setup option in the
Camera Setup screen is not enabled.)
4.3.4 PTZ control select
This option lets you select PTZ control device. By clicking Select
button, the following PTZ control setup window for Chateau System
prompts. (Provided that camera name, type and address in the I/O
Device window on the System functional section must be set up in
advance.) Then, click the desired PTZ control device entry.
4.3.5 Alarm setup
By clicking Enable Alarm then click Setup Chateau System will enter
Alarm setup. Please refer to Chapter 6: Alarms for more detail.
4.4 Preview
During recording, a user needs to preview image certain time; select the
desire camera under recording window. Click the right button of the mouse,
and select Preview. The following will show:
Input the time needed for preview, (The time at the right hand side is the
time which you select this function). Time range for preview is 1~99
minutes.
If there is no recorded image in the preview time set, the system will
automatically search for the earliest file for playback in the time range.
When there is no valid recorded file saved due to the short recording time,
or when there is not file in the appointed time, an invalided message will be
shown.
While remote monitoring and recorded, because the image will be saved in
the remote system’s database, so the preview function is still available.
Operation is as same as local host. When the selection of not recording
while remote monitoring is selected, then this function will not be available.
52