User`s manual

1. Monitoring and Recording (Display camera images): Activate
recording options and display image options.
2. Monitoring but not Recording (Display camera images): Inactivate
recording options and open display view options.
3. Recording but not Monitoring (Display Working): Activate
recording options and close display image options.
4. Not recording and not monitoring (Display Working): Inactivate
both recording options and display image options.
When the “Recording” mode is turned on, the System Status panel is
shown as VIDEO. When the recording mode is turned off, the System
Status panel will not been shown.
Audio recording will be activated at the same time when the indicated
camera starts recording when the “Enable audio” mode is turned on.
System Status panel is shown as AUDIO. When the mode is turned
off, the System Status panel will not been shown.
51
4.3.3 Motion Detection Setup
During recording, if you select a motion detection area (by clicking on
the original point, holding the left button of the mouse, dragging it to
the desired point, and then releasing the button.), the system then
undertakes motion detection against the selected area. There is a
limit of 5 mask area can be set for motion detection. Only System
Administrator can see, setup and delete motion detection area.
The mask area in the photo on the left is
the motion detection area. The green
color frame means that no alarm is
triggered.
In the left photo, the detection area is
shown in red color, to mean that an
alarm is triggered. (Enable Alarms of the
Alarm Setup option on the Camera
Setup screen must be enabled before
alarm triggering can work for the motion
detection area.)