User`s manual
Table Of Contents
- System Specification
- System Introduction:
- System Front Panel:
- USB
- Number 1-8 Buttons
- Number 9 Button
- Number 0 Button
- Power Indicator（）
- Recording Indicator（）
- Playback Indicator（）
- Record/ Switch to Recording Display Button:
- Setting / List Button
- Leftward Button / Playback Backward
- Upward button / Step Playback / Pause Playback
- Rightward Button / Playback Forward / Output Control
- Select / Backup Button
- Playback Button
- Subtract 1 / Next / Slow Speed Playback
- Downward Button / PIP Function
- Add 1 / Last One / Fast Speed Forward
- Cancel / Stop / Alarm Log Button
- System Back Panel:
- Hard Disk Installation:
- System Front Panel:
- System Setting
- Record
- Playback
- PIP Function
- Alarm Log
- I/O
- File Backup
- Network Function
- VG Player
There are four types for remote: Server; IP, PC DVR and Embedded
DVR. In these, Server supports connection from several remote points
from PC DVR and Embedded DVR. PC DVR and Embedded DVR can
only support point to point connection. IP then used as remote alarm
between PC DVR.
Port setting for different remote types as below:
Type: Server PC DVR Embedded DVR
Port: 40000 40001 50000
Port for server is based on the Server setup. Defaulted is 40000; PC
DVR port is based on the LAN port setup for Chateau Software.
Defaulted is 40001; Embedded DVR port is based on the LAN port
setup for VGN Embedded DVR. Defaulted is 50000.
Click
to link to remote access, you should be able to see the list
of the Address book setting above. Double click on this TCP/IP list, if
network setting is correct, a “connected” will be shown. This means
you had successfully connected with remote site.
From the Host panel on the right hand side of Chateau main program,
you should be able to see the name for all connected systems.
Select the system name you like to monitor, the split window
46