User`s manual
Table Of Contents
- System Specification
- System Introduction:
- System Front Panel:
- USB
- Number 1-8 Buttons
- Number 9 Button
- Number 0 Button
- Power Indicator（）
- Recording Indicator（）
- Playback Indicator（）
- Record/ Switch to Recording Display Button:
- Setting / List Button
- Leftward Button / Playback Backward
- Upward button / Step Playback / Pause Playback
- Rightward Button / Playback Forward / Output Control
- Select / Backup Button
- Playback Button
- Subtract 1 / Next / Slow Speed Playback
- Downward Button / PIP Function
- Add 1 / Last One / Fast Speed Forward
- Cancel / Stop / Alarm Log Button
- System Back Panel:
- Hard Disk Installation:
- System Front Panel:
- System Setting
- Record
- Playback
- PIP Function
- Alarm Log
- I/O
- File Backup
- Network Function
- VG Player
VGN Embedded DVR network setup
1. If the recording site (VGN Embedded DVR, and Chateau) is using
real IP address for internet (ie.211.175.21.43)
VGN Embedded DVR network setting is as follow:
Communication Port Setup: LAN: 50000; WAN no special value
required.
Chateau Network setting as follow:
Communication Port setup: LAN: 40001; WAN no special value
required.
2. If the recording site (VGN Embedded DVR, and Chateau) is using
a virtual IP address under LAN (i.e. 192.168.2.20) and the monitored
site is under the same LAN:
VGN Embedded DVR network setting is as follow:
Communication Port Setup: LAN: 50000; WAN no special value
required
Chateau Network setting as follow:
Communication Port setup: LAN: 40001; WAN no special value
required
3. If the recording hosts (VGN Embedded DVR, Chateau Hosts) is
under LAN with virtual IP address (i.e. 192.168.2.20), the remoted
host is not under the same LAN and is remote through Internet, then
you will require doing NAPT (Network Address Port Translation) in
your router to correspondence. You can then be able to connect to
the VGN Embedded DVR, Chateau system for remote through
router under LAN.
VGN Embedded DVR network setting as below
44