User`s manual
Table Of Contents
- System Specification
- System Introduction:
- System Front Panel:
- USB
- Number 1-8 Buttons
- Number 9 Button
- Number 0 Button
- Power Indicator（）
- Recording Indicator（）
- Playback Indicator（）
- Record/ Switch to Recording Display Button:
- Setting / List Button
- Leftward Button / Playback Backward
- Upward button / Step Playback / Pause Playback
- Rightward Button / Playback Forward / Output Control
- Select / Backup Button
- Playback Button
- Subtract 1 / Next / Slow Speed Playback
- Downward Button / PIP Function
- Add 1 / Last One / Fast Speed Forward
- Cancel / Stop / Alarm Log Button
- System Back Panel:
- Hard Disk Installation:
- System Front Panel:
- System Setting
- Record
- Playback
- PIP Function
- Alarm Log
- I/O
- File Backup
- Network Function
- VG Player
Live Audio: When this is activated, and you had connected audio
input to the correspondence cameras, you are able to have live audio
monitoring when the sound is connect to a speaker.
ALARM RECORD: When system not under recording mode, after
activated of this function, the system will start recording after alarm
triggered. Recording time is the time set between alarm intervals with
3-5seconds pre-alarm. Also input points can activate alarm records.
Recording time is the signal input time.
VGA-PIP: PIP (Picture in Picture) functions us use to see both record
and playback images at once. When it is set at on (activate), press the
bottom, there will be a sub-window showing on the VGA
monitor. Then both recording and playback images can be see at the
same time. Press the bottom again then the sub-window will be
disappeared.
Note: PIP function can only support by VGA output connects to
VGA monitor. TV monitor does not support this function.
3.6 Network Setup
NETWORK SETUP : SERVER SETUP
1.HOST NAME VGN8C-----
2.CONNECT SERVER ON
3.SERVER 192.168.16.127
------------
4.SERVER PORT 40000
5.DISCONNECT ALM -- -- -- --
Network Setup is to setup the network connection function. You can
setup the system’s network connection and also you can setup 4 sets for
remote user’s name, password, authorization and camera.
You will require setting the “Connect Server” to off before setup/alter
Network Setup and Remote User.
Server Setup:
When enter this setup, the above server setup pages will be shown.
21
Host Name: Host name is used for recognition when connecting