User`s manual

20
relay output control terminals for selection. This output control
terminals is optional.
3.5 System Setup
SYSTEM SETUP
1.VIDEO MODE NTSC
2.RECORD SPEED 30
3.VIDEO QUALITY 10
4.SCAN TYPE QUAD DISPLAY
5.SCAN INTERVAL 3
6.AUTO RECORD ON
7.LIVE AUDIO ON
8.ALARM RECORD OFF
9.VGA-PIP OFF
 Video Mode: Video modes include the selection of NTSC and PAL.
Users must change it according to your local video mode. You will
need to stop recording before changing the setting.
 Record Speed: Maximum recording speed per channel is 30fps
NTSC or 25fps PAL.
 Video Quality: Video quality range is from 1-10. Quality 10 means the
best quality however the largest the recorded file sizes. User’s can
change the video quality to your needs. However, low quality also will
influence the playback quality.
 Scan Type: This is to setup the auto scan type. FULL DISPLAY
(single camera full screen display, recycling for every channels), or
QUAD DISPLAY (4 split window /2 pages display,), or Eighth Display
(as 9 split windows and 4 pages display)
 Scan Interval: This is to setup up the interval for auto scan. Defaulted
is 3 seconds. Maximum interval time is 99 seconds.
 Auto Record: When auto record is set at ON (activate), when
system reboot, system will automatically start recording. If this setting
is OFF (disable), then user will need to press the record button
manually for the system to start recording.