User`s manual
Table Of Contents
- System Specification
- System Introduction:
- System Front Panel:
- USB
- Number 1-8 Buttons
- Number 9 Button
- Number 0 Button
- Power Indicator（）
- Recording Indicator（）
- Playback Indicator（）
- Record/ Switch to Recording Display Button:
- Setting / List Button
- Leftward Button / Playback Backward
- Upward button / Step Playback / Pause Playback
- Rightward Button / Playback Forward / Output Control
- Select / Backup Button
- Playback Button
- Subtract 1 / Next / Slow Speed Playback
- Downward Button / PIP Function
- Add 1 / Last One / Fast Speed Forward
- Cancel / Stop / Alarm Log Button
- System Back Panel:
- Hard Disk Installation:
- System Front Panel:
- System Setting
- Record
- Playback
- PIP Function
- Alarm Log
- I/O
- File Backup
- Network Function
- VG Player
2.2 System Back Panel:
System’s back panel is mainly for signal connection. Detail information as
followed:
Power Supply
Mark 1: This is for the power supply input socket. You can directly
connect to AC 110V/60Hz or 220V/50Hz.
Ethernet RJ45-jack
Mark 2: This is for RJ45 Internet connection socket. This is for
10Mbps/100Mbps Ethernet
USB
Mark 3: This system has 2 USB sockets. This is for connecting to USB
devices for backup images or update firmware.
Power
Mark 4: Power on/off. To turn on/off the system power.
VGA Output
Mark 5: VGA Output to connect to VGA monitor.
Video Input BNC-jacks
In RT4 System, Mark 6: Video Input 1-4 (From left to right); Mark 10:
Video Input 5-8 (From top to bottom).
In HRT4 System, Mark 6: Video Input 1-4 (From left to right); Mark 10
for 3 sets Video Input 5-16 (From top to bottom). Set order as red,
white black and yellow.
In SRT4 System, Mark 6 for 4 sets Video Input 1-16 (From right to left).
13