Owner`s manual

THE ICE-DUCER™ SYSTEM*

The Ice-Ducer system provides a quick and easy way to set up the trans-

ducer for ice fishing. All of the adjustments needed to find the true per-

pendicular point are done automatically. To use the Ice-Ducer, simply

adjust the transducer to the desired depth and drop the assembly in the

ice hole.

There are three main components to the Ice-Ducer sys-

tem. They include the transducer, float, and the stop. The

transducer comes assembled with the connector already

installed. The stop is put on by passing the transducer cord

through the slit in the side of the stop. The float is installed

between the stop and the transducer in the same way. Make

sure the countersunk hole is facing up towards the top. The

stop will rest in this hole.

To use the Ice-Ducer, adjust the stop to allow the trans-

ducer to float at the desired depth. A six inch minimum is

recommended in order to make sure that the transducer

will be pointing straight down. Ideally, the farthest it should

be down is to the bottom of the ice hole. If the transducer

is below the bottom of the ice it can cause tangling prob-

lems when bringing in fish.

If you run into problems when using the Ice-Ducer and

you can't see your bait try this, rub the bottom of the trans-

ducer with water to eliminate any residue or air film. This

insures good contact between the transducer and the water.

Check the length of cord between the float and the trans-

ducer to make sure there are no kinks in the cord that will

cause the transducer to shoot off to the side.

*Patent no. 5,546,362

The Ice-Ducer

System