Owner`s manual

4
INSTALLATION
To be able to use the FL-18, you must provide the unit with power and
mount the transducer in an appropriate location.
UNIT INSTALLATION
Find a convenient place to mount
the unit. This may include a boat
seat, deck, dash, or a portable case.
Make sure that there is plenty of
room for the unit to tilt and/or
swivel freely without the cables
binding behind the unit. Once you
have found a spot, remove the unit
from the gimbal bracket. Securely
attach the bracket to the mounting
surface.
POWER CONNECTION
Plug the flat 3 pin connector into the back of the unit. Find the closest
source of 12 volts and run the cord to it. Keep the cord away from sharp
metal edges and avoid tight places where the cord may get crushed.
Connect the red wire to positive and the black wire to negative or ground.
If the cord provided is not long enough, more can be added. Use 18 gauge
wire minimum. For boat installations, it is recommended that a 1 amp
in-line fuse be placed in the positive line as close to the power source as
possible to protect against any shorts in the wiring.