Installation manual

www.desatech.com
118531-01C32
7. Loosen set screw on main burner air shut-
ter, rotate to fully open, and retighten set
screw (see Figure 56).
8. Reposition burner with air shutter placed
over orice mount and replace two screws
on rear log stand and two screws at pilot
assembly.
Figure 54 - Removing Logs and Burner
Assembly
Figure 57 - Converting Pilot Orice
PILOT ORIFICE CONVERSION
1. Remove pilot hood by pulling up until it
disengages from barrel. Do not remove
retainer clip (see Figure 57).
2. Remove pilot orice from inside barrel
using 5/32" allen wrench to unscrew
orice.
3. Replace pilot orice with LP orice sup-
plied with kit. The number 30 is stamped
on the sleeve for identification. Insert
small end of new pilot orice into barrel
and thread until tight with allen wrench.
4. Line up notch on pilot hood to positioning
tab on barrel receiver and snap into posi-
tion. IMPORTANT: Be careful not to bend
or kink aluminum tubing during conver-
sion. Make sure pilot hood and orice are
properly mated and aligned after nishing
the conversion.
Figure 55 - Removing Main Burner
Orice
Figure 56 - Adjusting Air Shutter
AIR SHUTTER ADJUSTMENT
Fully Open = Propane/LP Gas
1/4" Open = Natural Gas
Air Shutter
Opening
Set Screw
1
1
/
8
" Wrench
11/16" Wrench
Orice
Mount
Pilot Hood
Pilot Orice
Barrel Clip
Pilot Bracket
5/32" Allen
Wrench
CONVERSION INSTRUCTIONS
Continued
Pilot
Bracket
Screws
Top Logs
Rear Log
Base Log
Rear
Panel
Rear
Log
Stand
Screws