Installation manual

www.desatech.com
118531-01C 29
MANUAL LIGHTING
PROCEDURE
1. Remove glass door (see Removing/Re-
placing Glass Door, page 25).
2. Follow steps 1 through 8 under Lighting
Instructions, page 28.
3. Depress gas control knob and light pilot
with match.
4. Keep gas control knob pressed in for
30 seconds after lighting pilot. After 30
seconds, release gas control knob. Fol-
low steps 9 through 12 under Lighting
Instructions, page 28.
5. Replace glass door (see Removing/Re-
placing Glass Door, page 25).
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 39). Follow instructions included with
the remote control.

-
Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON position.
Adjust ame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 49).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
O
F
F
P
I
L
O
T
L
O
I
H
ON OFF REMOTE
ON
OFF
O
N
Blower Control Knob
(Optional Accessory)
Variable Control
Knob
Selector Switch in
Remote Position
Gas Control Knob
in ON Position
Figure 49 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation

Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 47).
 press both buttons on hand-held
remote control until light stops ashing. Hand-
held remote control is now locked. If the re
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
  press both buttons together on
hand-held remote control until the light stops ash-
ing. The hand-held remote is now unlocked.
OPERATION
Continued
Figure 50 - On/Off Hand-Held Remote
Control Unit HRC100
Control
Button
Indicator
Light
THERMOSTAT SERIES MODEL
HRC200
The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure 51,
page 30). To select Fahrenheit/Centigrade
mode display, carefully press the ˚C/˚F mode
button with the end of a paper clip or similar
blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
replace.
3. Press the POWER and LOCK buttons
together to turn off the replace.

1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.