Installation manual

www.desatech.com
118531-01C28
OPERATION
FOR YOUR SAFETY

WARNING: If you do not fol-
low these instructions exactly,
     
-

 
-

 -



WHAT TO DO IF YOU SMELL GAS



    


 





       





LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information
above.
2. Open lower louver panel.
3. Turn off all electric power to replace.
4. Push in gas control knob slightly and turn
clockwise to OFF.
5. Wait ve (5) minutes to clear out any
gas. Then smell for gas, including near
the oor. If you smell gas, STOP! Follow
“B” in the safety information above. If you
don't smell gas, go to the next step.
6. The pilot is located by the main burner and
should not require accessing for lighting.
7. Turn gas control knob counterclockwise
to PILOT (see Figure 45).
8. Push in gas control knob all the way and
hold. Immediately light pilot by repeatedly
pressing piezo spark ignitor until a ame
appears. Continue to hold for about one
(1) minute after pilot is lit. Release gas
control knob and it will pop back. Pilot
should remain lit. If it goes out, repeat
steps 5 through 8.
• If gas control knob does not pop up when
released, stop and immediately call your
service technician or gas supplier.
• If pilot will not stay lit after several tries,
turn gas control knob to OFF and call your
service technician or gas supplier.
9. Turn on all electric power to replace.
10. Turn gas control knob counterclockwise
to ON.
11. This valve is equipped with a HI/LO fea-
ture. Set replace input as desired.
12. Close lower louver panel.
13. To leave pilot lit and shut off burners only,
turn control knob clockwise to the
PILOT position or set selector switch in
the OFF position.
Figure 48 - Control Valve
P
I
L
O
T
O
F
F
P
I
L
O
T
O
N
TPTH T P T H
HI
LO
IN
OUT
Gas Control
Knob
Variable
Control Knob
Piezo
Ignitor
TO TURN OFF GAS
TO APPLIANCE
1. Open lower louver panel.
2. Set selector switch in the OFF position to
prevent draining battery.
3. Turn off all electrical power to appliance
if service is to be performed.
4. Push in gas control knob slightly and turn
clockwise to OFF.
5. Close lower louver panel.