Installation manual

www.desatech.com
118531-01C 27
FIREPLACE
INSTALLATION
Continued
Figure 45 - Removing/Replacing Glass
Door
Figure 46 - Installing Logs
Top Left
Log
Front
Log
Top
Right
Log
Rear
Log
Rear Log
Stand
Log Mounts
Burner
Pan
Latch
UNLOCK
LOCK
Door Frame Tab
Glass Door
Panel
6. Remount new frame in reverse order by
placing positioning tabs on the glass frame
into slots in retaining bracket then swinging
door into sealed position and locking two
latches in place.
7. Replace top louver panel, and then lower
louver panel.


A 4 piece ceramic log set comes packed
inside the unit rebox. Removal of glass door
is necessary to unpack and assemble the
logs and add hearth treatments. Follow steps
under Removing/Replacing Glass Door, page
25 to access the logs and burner.
Assemble logs and add burner treatments
as follows:
1. Position base log onto burner log mounts
(see Figure 46). Note: Cut out on the bottom
should t over mounts and base log should be
positioned against rear panel.
2. Position holes on the bottom of rear log over
pins on base log see Figure 46).
3. Position top left log and top right log onto
rear log and base log as shown in (see
Figure 46).
    




4. Open bag of ember materials.
5. Break apart about quarter sized pieces
and place a single layer along full length
of ember tray to hide bottom edge of base
log (see Figure 47).
6. Replace glass door and louver panels.
See Removing/Replacing Glass Door,
page 25.
Ember
Material
Ember
Tray
Figure 47 - Applying Ember Material