Installation manual
www.desatech.com
118531-01C26
FIREPLACE
INSTALLATION
Continued
-
-
1. Grasp lower louver panel and pull up until
hanger brackets release from door pins
(see Figure 43).
2. Swing louver panel out until it clears re-
place opening.
3. Pull entire panel out until bottom tabs
are free of slot openings in lower face
frame.
Figure 43 - Removing Lower Louver
Access Panel
Door Pin
Hanger Bracket
Lower Louver
Access Panel
1. Grasp two hanger brackets at bottom
and pull up until hanger brackets release
from door pins (see Figure 44).
2. Swing out bracket ends until upper panel
tabs can be angled out of slot openings
in the upper face frame.
3. Pull entire louver trim panel out of face
frame.
-
Figure 44 - Removing Top Louver Trim
Panel
Panel Tabs
Top Louver
Trim Panel
Door Pin
Hanger
Bracket
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced.
If glass is broken, wear gloves and tape the
remaining fragments onto frame.
1. Remove lower louver panel (see Re-
moving Lower Louver Access Panel and
Figure 43).
2. Remove top louver trim panel (see
Removing Top Louver Trim Panel and
Figure 44).
3. Hold glass frame with one hand and with
other hand unlock two door latches found
on top of rebox to release tension on
door frame (see Figure 45, page 27).
4. Unhook locking clasp from tabs on door
frame and with both hands swing door
panel out while pivoting lower frame on
the lower retaining bracket.
5. Lift lower frame tabs out from position-
ing slots found on lower frame retaining
bracket (see Figure 45, page 27).