Installation manual

www.desatech.com
118531-01C 19
5. Remove two screws and outer cover on
left side of the outer cabinet.
6. Reinsert junction box retaining flange
through slot now on left side and swing
screw mounting tab back through notch
as before.
7. Slide junction box down till mounting tab
holes line up and replace inner retaining
screw.
8. With junction box cover removed, pull
end of 3-wire Romex supply line through
universal strain relief bushing on cover
(see Figure 26, page 18).
9. Strip back outer Romex to about 4" and
connect black, white and green wires ac-
cordingly using 3 wire nut connectors.
10. Tuck tailing wires into junction box and
replace junction box cover using 2 remain-
ing screws.
11. Tighten down strain adjustment on uni-
versal bushing until Romex sheathing is
secured.
The electrical connection is now complete.

ACCESSORIES
  
    
-



WARNING: If there is a du-
   

     
    

-
     

FIREPLACE
INSTALLATION
Continued

Follow all instructions provided in the blower
accessory kit.
1. Attach power cord to blower motor by rmly
pushing two female terminals at end of
power cord onto two spade terminals on
blower motor (see Figure 27).
2. Attach green ground wire from power
cord to blower housing using screw pro-
vided (see Figure 27). Tighten screws
securely.
3. Place blower against lower rear wall of
rebox outer wrapper with exhaust port
directed upward. Blower will t inside
the back opening and be held in posi-
tion against back wall by magnets (see
Figure 27).
4. Be certain that all wire terminals are securely
attached to terminals on blower motor and
that screw retaining green ground wire is
tight.
5. Mount speed control box by placing plastic
control shaft through opening in switch
bracket (see Figure 28).
Blower Location
Side View
Figure 27 - Blower Model BK
Magnetic
Strips
Exhaust Port
Screw
Green
Ground
Wire
Spade
Terminals
Lower Firebox
Cavity
Figure 28 - Attaching Speed Control to
Firebox (Millivolt Models)
Speed Control
Control Shaft
Locknut
Control
Knob
Switch
Bracket
Blower
Plug-In
Duplex Outlet
(Located underneath
rebox oor against
lower right outside wall)