Guide
1+4
6.2
6.1
Random Mode Spiral Mode Lawnmower Mode
I.5
I.7
I.6
Autopilot Robot Build
See the Autopilot Robot Assembly Instructions in your kit documentation.
Default Sensor Functionality Exercises
Touch LED Default Functionality Exercise: “Stop and Go”
The default Touch LED functionality in the Driver Control program is to act like a trac light for the
robot. Using the Autopilot or similar robot with ONLY Smart Motors and Touch LED connected to any
unused port in the Robot Brain:
- Turn ON the Robot Brain and Controller.
- Select and run the Driver Control program.
- The robot starts in enabled mode with the Touch LED glowing green. Tap the top dome of the
Touch LED to change between enabled (glowing green) and disabled (glowing red).
- Try to drive when green
- Try to drive when red
Running Autopilot Modes
Your teacher will decide what of the lessons below you will complete as part of the unit. Below are the
lessons along with necessary information.
I. Read and review Key Terms and Sensor Overview with your classmates and teacher.
II. Complete the unit Matching Exercise. See separate handout.
III. Build Autopilot Robot. See the Autopilot Robot Assembly Instructions in your User Guide.
IV. Use Autopilot Robot to run the three Autopilot Modes.
These are demonstrations of dierent ways Sensors can work together
in a Smart Machine. See your kit documentation for details.
V. Default Sensor Functionality Exercises
See your kit documentation for details in addition to information below.
Green Red