Instructions / Assembly

- 53 -
Nozzle Spray Tip is too
large or WOITI.
Replace the Nozzle Spray Tip.
Pressure is set at
maximum but cannot
achieve a good spray
pattern.
Nozzle Spray Tip is in the
Unclog position.
Relieve pressure and rotate the Nozzle
Spray Tip so the arrow is pointing away from
the handle.
Nozzle Spray Tip is too
large for the paint being
sprayed.
Select a smaller Nozzle Spray Tip.
Nozzle Spray Tip is worn.
Replace the Nozzle Spray Tip.
Extension cord is too long
or not heavy enough
gauge.
Replace the extension cord with a 12 AWG cord.
Spray gun fluid filter is
clogged.
Clean or replace the spray gun fluid filter.
Inlet screen is clogged.
Clean debris from inlet screen.
Pumpvalves are worn, or
debris is clogging the
valves.
To check for worn pump valves: Prime the
sprayer with paint. Trigger the gun
momentarily. When the trigger is released, the
pump should cycle momentarily and stop. If it
continues to cycle, then the pump valve may
be worn.
Paint material is too thick.
Thin the paint material.
High pressure hose is too
long.
If another hose section has been added, remove
the hose extension.