Instructions / Assembly

- 30 -
7.Sprayer will start pumping and water or
flushing solvent well as air bubbles will be
purged from system let fluids discharge
from Priming Tube into waste bucket for 30
to 60 seconds then switch Power to Off
8. Remove Suction Tube
from water or flushing
solvent and submerge in
paint pail
9. Switch Power to On
10. Paint should work itself from Suction
Tube to Sprayer to Priming Tube until paint
discharges from Return Tube Point gun into
waste bucket and pull trigger
11. Turn Spray/Prime
Switch to Spray
mode and continue
to spray into waste
bucket
12. Stop spraying
and activate trigger
lock
13. Remove the Priming
Tube from the waste
bucket and clip to
Suction Tube and
submerge in paint pail
14. Si le moteur s'arrête, la pompe et les tubes sont amorcés. S'il ne
s'arrête pas, répétez les étapes d'amorçage.
15.Commencer à peindre
Amorçage