Instructions / Assembly

- 34 -
2.Spray tip or fluid filter may be
clogged
2.Relieve pressure,then Then
clear clog or lean gun filter
Basic
Mechanical
1.Pump frozen or hardened pain
1.Thaw sprayer if water or
water-based pain has frozen
in sprayer.Place sprayer in
warm area to thaw. Do not
start sprayer until thawed
completely.If paint hardened
(dried)in sprayer replace
pump packing
2.Displacement pump connecting
rod pin
Pin must be completely pushed
into connecting rod and retaining
spring must be firmly in groove or
pump pin
2.Push pin into place and
secure with spring retainer
3.Motor.Remove drive housing
assembly
3.Replace motor if fan won't
turn
Low Output
1.Worn spray tip
1.Relieve pressure,Replace
tip
2.Verify pump does not continue to
stroke when gun trigger is released
2.Service pump
3.Prime valve leaking
3.Relieve pressure,Then
repair prime valve
4.Suction tube connections
4.Tighten any loose
connections.Check o-ring
on suction tube
5.Electric supply with volt meter
Mater must read 220-240 Vac.Low
voltages reduce sprayer
performance
5.Reset building circuit
breaker, replace building
fuse.Repair electrical outlet or
try another outlet
6.Extension cord size and length
6.Replace with a
correct,grounded extension
card