Instructions / Assembly

- 22 -
pressure rating, or fluid-carrying capacity highly abrasion resistant.
 Extremely durable.
Operating Instructions
BEFORE STARTING
(1)CHECK all fittings and connections in the pump system, hose, and gun
to ensure that they are tight.
CHECK to ensure that there is a spray tip in the gun, and that the tip is the
correct size for the coating you are to spray. (There are various tips
available, for each type of coating or configuration.)(2) MAKE SURE the
power source is securely grounded and matches the motor rating of your
sprayer.
(3) New spray: Oil is used by the factory for testing and protection. It is
necessary to flush unit before spraying. Clean the pump with warm soapy
water. Make sure the hydraulic oil in the pump is clean and sufficient in
volume then begin the following procedure.
1. Remove spray tip from gun.
2. Put the input hose and pressure relief tube into the bucket with some
water,3. Turn on the motor and push the pressure valve upright. In a few
seconds, water will begin to flow up through the tube and flow out from
outlet valve, tighten the outlet valve deasil, then tighten the pressure valve
deasil.
4. When the pressure reaches up to around 207 bar, check if there is any
leakage on the outlet hose. If it's leak, please check. Don't stop or deflect
leaks with your hand, body, glove or rag.
5. If doesn't leak, open the spray gun and have a testing spray. Clean the
oil in pump. Change the soapy water and use clean water when the spray
is clean
6. Turn off power. Continue to spray till no water is out.
7. Unlock trigger lock. Put the pressure valve upright, till no soapy water in
pump.