Instructions / Assembly

- 8 -
5.Maintenance Guide
1. Place the product on a sturdy, secure, accessible, and level starting
point. The minimum weight capacity of the starting point must be equal
to that of the ramp (800 lbs). Do not exceed the maximum weight
capacity of the product.
2. Ensure that the product is securely flush against the starting point. If a
safe, accessible, and level starting point cannot be found, or if the
product does not fit securely against a higher starting point, do not use
the ramp.
3. Do not tamper with, attempt to repair, or modify any part of the product.
Exercise caution to avoid pinch points during assembly and handling.
4. If using the product with other mobility equipment, refer to the user
guide of the equipment to understand the acceptable usage guidelines,
including appropriate slope, incline, and chair direction. Do not exceed
the recommendations of the mobility equipment.
5. When using the ramp, ensure it is securely flush against the starting
point to ensure safety.
6. Before each use, clean the ramp surface of ice, snow, dust, leaves,
and other debris. Remove accumulated ice and snow, and sweep the
surface clean. For dust and debris, use a soft bristle brush and
non-alkaline detergent to clean the ramp surface, then rinse
thoroughly.
7. The ramp surface may become slippery in wet conditions. Walk with
caution and pay attention to your footing to prevent slipping.
8. If the ramp will not be used for an extended period, store it in a dry and
well-ventilated area away from direct sunlight.
9. Do not use thinner, gasoline or other volatile organic solvents to clean
the product.
10. Do not scrub this product with a hard brush or hard sponge.