Use and Care Manual

6. ice making machine should not be installed in the
environment without sewer and water seepage, and it is
strictly prohibited from high temperature equipment.
7. air-cooled ice making machines (such as refrigerators, ovens, etc.) rely on
air circulation to dissipate heat. So it is necessary to keep the space above
15cm to benefit the heat dissipation.
-4-
Installation of Water Supply
1.The ice maker must use drinkable normal atmospheric temperature
filtered water.
2.Water pressure of water supply must be controlled between
0.3~3MPa, if over pressure pressure reducing valve need to be installed.
Don’t make the water inlet hose be squeezed.
3.The two ends of the water inlet hose are 3 / 4 " internal thread
( 20mm ) and 1 / 2 " internal thread ( 15mm ) joints with silicone seal
washers, so no need to wind tape.
4. The water filter is equipped with a filter element, unscrewing it with a
filter wrench before using the water filter. Take out the filter element,
tearing up the packaging film of filter element, putting it back as it used
to be and screwing up it. Changing the filter element every half year in
the process of use.
5.Please notice that the filter cover has the water inlet and the water
outlet direction marks.
6.Connecting the joint of 3/4 "with the water inlet of the machine(white
3/4" outer thread), and connect the joint of 1/2 "with water supply pipe.
7.Water-cooled ice maker, added one inlet and one outlet joints of
3/4” external thread pipe, the black color distinguishes them from the
water intake of making ice.
8. The ice maker is drained by gravity. Therefore, it is necessary to
ensure that the drainage pipe has sufficient slope and drop.