Use and Care Manual

-22-
Ice Maker Work Steps
The working steps of the ice maker are divided into three parts :
1. The automatic cleaning of the ice machine ( once, time 2 minutes )
When each ice maker starts, the automatic 2 minute cleaning program is
automatically carried out to clean the floating objects in the ice grid and the
tank. In 2 minutes the sink uninterrupted water, pump operation. The user can
hear the noise of the pump work flow from the top of the ice grid down into
the sink, and then overflow from the sink, from the drain outlet of the ice
storage bucket.
2. Ice ( cycle work, the longest 40 minutes )
After the completion of automatic cleaning, the pump will delay 45 seconds to
start, and then the ice began. When making ice, the water pump works
continuously from above the ice grid to the sink, and the water will slowly
become cold until it freezes. Ice thickness is measured by the ice thickness
detector during the ice making process. When the thickness of the test is
reached, the program will turn to the de-icing step. If the gap of the ice
thickness detector is too large, it will be forced into the de-icing program after
more than 40 minutes of ice making time.
3. De-icing ( cycle work, up to 4 minutes )
In the de-icing procedure, ice will be heated, ice and ice grid will be the
connection will be melted, when the ice due to weight and can not be attached
to the ice grid, it will fall off, complete a de-icing process.
When the ice falls, the water plate will be turned over, and then the water
retaining plate will be reset due to the dead weight, and then the machine
starts to make ice again. When the ice bucket is too much ice, the ice block can
not be reset, and the control chip is judged to be full of ice and temporarily
shut down until the water retaining plate is reset.
Fault self-diagnosis
1. Pump -- can directly observe whether there is water from the ice grid
up, if there is no pump failure.
2. Refrigeration--after 10 minutes of ice making, the water in the sink will
be significantly cooler, and you can feel the water temperature directly by
touching the ice grid or running water.
3. Influent-- one by one in the automatic cleaning process can be
observed in the tank overflow pipe constantly flowing into the ice storage
tank. In the process of ice making, you can put your hand into the water
tank to feel the amount of water, the normal situation accounts for more
than half of the sink.