Instructions / Assembly

It is possible to over trim the engine and increase the steering torque

to the point that the steering wheel cannot be turned, even though

the torque is not felt at the wheel. This may give the impression that

the steering is “locked”. This condition can occur more when jack

plates are used to raise the engine on the transom, and can only

be overcome by reducing the boat speed or engine trim out position.

Until you are completely familiar with the boat and the effects of

power trim, make all adjustments of trim with extreme caution.

Loosening or loss of one or more fasteners may cause failure of

the steering system, resulting in loss of steering control

and could cause property damage, injury, or death.

DO NOT cover cracks with tape or other sealants, this will create

a hazard in which the cable can fail suddenly without warning,

resulting in property damage, injury, or death.

DANGER

1. After a few hours of operation and at frequent intervals thereafter,

check all fasteners and the complete steering system for security and

integrity.

2. Keep all moving parts free from build-up of salt and other foreign

material. This will affect their operation and create steering problems.

Periodically remove the cable, clean support tube and telescopic end of

cable thoroughly and lubricate with a waterproof marine grease.

3. Periodically inspect for corrosion. Any parts affected by corrosion

must be replaced. When replacing hardware, self-locking hardware as

originally supplied must be used.

4. Periodically inspect steering cable for cracks or other damage.

If any is found the cable must be replaced.

5. If cable is stiff in operation, it is unsafe to use and must be replaced

immediately.

Boat builder and boat dealer, please supply these Installation

Instructions and Owner’s Manual with the delivery of boat. Boat owner

keep these instructions with your boat for future reference. Boat owner

consult with your boat builder, boat dealer, or Vevor if you

have any questions regarding these instructions.

NOTICE

Operation & Maintenance Notes

CAUTION