Instructions / Assembly

COMMAND HL100
STEERING SYSTEM
292748 (90° Bezel Kit)
292747 (20° Bezel Kit)
Installer: these instructions contain important safety information and
must be forwarded to the boat owner.
NOTICE
The Vevor Command HL100 Steering System is designed to
mount
the wheel parallel to the dash, or 20° from parallel by using one of the
Bezel Kits—90 degree or 20 degree.
Throughout the text, part names are followed by a number in
parentheses. Refer to Parts Breakdown on the last page for visual
identication
Helms and cable assemblies are supplied lubricated ready for installation, do
not add any lubricant to either assembly. Use of other lubricants can
cause damage to the steering cable, resulting in the cable seizing or
premature wear. Keep the cable and drive assembly clean during
installation. Dirt will damage the system and cause premature wear.
Do not take the plastic sleeve off the end of the cable until you are
ready to install it into the helm.
This notice does not include the engine output ram end of the cable.
NOTICE
When replacing an existing steering system it is recommended that you stay
with the style (rotary or rack) the boat manufacturer installed. Never change
your steering from a dual cable to a single cable system, as this could cause
an unsafe boating condition.
Before starting installation read these instructions and engine
makers instructions thoroughly. Failure to follow either of these
instructions or incorrect assembly can result in loss of control and
cause property damage, injury, or death.
DO NOT substitute parts from other manufacturers, they may cause
a
safety hazard for which Vevor cannot accept responsibility. Use
only Vevor steering cables with this helm.
To avoid excessive steering loads, and to get the best steering
performance, the outboard motor or outdrive trim tabs and tilt
position must be adjusted as instructed in the motor manufacturers
operation manual. Failure to do so can effect the performance of
the boat and its safe operation which may cause property damage,
injury, or death.
WARNING
WARNING
WARNING
DO NOT attach any electrical ground wires to the helm. This would
result in an electrolytic reaction to the steering system that may
result in system failure or greatly reduced service life.
WARNING
OUTBOARD APPLICATIONS: This system is only recommended as
replacement for the original system as installed by the boat manufacturer.
Vevor always recommends VEVOR™ (or No Feed Back) helms for
outboard applications. VEVOR™ helms lock out steering loads caused by
propeller torque eliminating the driver fatigue normally experienced with a
standard helm. Patented SeaStar Solutions VEVOR™ steering helms are a
drop in replacement for Command HL100 systems.
NOTICE
NOTICE
Page 2 of 6