Instructions / Assembly

- 11 -
(2) Remove the filled bottle, put down an empty bottle, press the [Tare]
[Run] button to start the next filling.
4"Automatic mode" operation method: (Press the [Auto] key, the
automatic light is on, enter the automatic mode)
Put the empty bottle, the system automatically peels and automatically
starts filling after a delay
of x seconds. When the weight reaches the filling weight, the filling is
automatically stopped.Remove the filled bottle and the system will
automatically reset to zero after a delay of x seconds.Put the next
empty bottle and automatically start the next filling.
Note: When using the automatic mode, if the machine is not properly filled,
it is because of a
mistake caused by a cycle not end yet.At this point, remove the bottle and
press [Tare] to use it normally.
5The setting method of "storing 4 groups of filling weights to M1-M4":
Press the [Save] key (the number of filling weights starts to flash), input the
value to be stored,
and finally press the [M1] key (the number of“filling weight" stops flashing)
and the number to be entered is stored in M1. When you need to use the
value of m1 as the filling weight, you can press m1 to set the value of m1
as the filling weight. (Set M2, M3, M4 as the method of setting M1)
6How to cancel the automatic peeling function :
Restart the machine, press the [Auto] button, and then hold down the [3]
button until you hear the alarm sound of the machine and let go. At this
time, the automatic peeling function has been cancelled.
If you want to turn on the automatic peeling function, repeat the above
operation. Once set up, the machine will remember forever.
7How to set the“MID-RANGE DECELERATION RATIO":At a few percent
of the set amount, it automatically goes to medium speed
Press [ auto ], set the flow rate to a proportional value (e. g.80) , press the
speed Knob long enough to let go when the“Beep"is heard.
8, How to set the "The value of slow down": (How many grams before the
end automatically slows down)
Press [Trig] [Save], .