Use and Care Manual

- 17 -
MOVING TAIL STOCK ASSWMBLY AND TOOL REST
The tail stock assembly and tool rest are held to the bed with lock handle
right underneath the bed rails.To move them to new position:
1. Disconnect the lathe from power source.
2. Loosen the lock handle with knob.
3. Slide the tail stock assembly or tool rest along the bed and retighten the
lock handle. (as figure)
MOUNTING THE LATHE
The lathe must be mounted to firm supporting surface such as a stand or
workbech when operating. To mount lathe:
1. Disconnect the lathe from power source.
2. Locate and mark where the lathe is to be mounted.(as figure)
3. Drill four(4) 5/16” diameter holes through work bench.
4. Place lathe on the workbench, aligning holes in bed with holes drilled in
workbench.
5. Insert four bolts(sold separately) and tighted.