Use and Care Manual

- 16 -
ADJUSTING SPEED
Four spindle speeds of 1100,1600,2300 and 3400 RPM (885, 1245, 1715,
2425) are available with lathe.Chart-1 illustrates which ster of the pullevs
the belt must be placed to obtain four speed.Chart-2 illustrates the proper
speeds for workpiece.
CHART-1
CHART-2
1. Disconnect the lathe from power source.
2. Open the belt and pulley cover.
3. Loosen the motor pulley by loosening the bolts with adjustable
wrench(as figure)
4. Place”V”belt to correct position for desired speed.
5. Adjust “V”belt to proper tension and tighten the motor pulley.
NOTE:For proper belt tension.press
down on the belt with hand.The belt
should move 1/2”when set properly