Use and Care Manual

- 14 -
The machine is very heavy. The machine shall be lifted from crate with a
suitable lifting device only that is certified to be able to carry the machines
load.
W A R N I N G
The lifting and transportation of the machine must only be carried
out by qualified staff and must be carried out with appropriate
equipment.
Preparation of the surface
Uncoated metal machine parts have been insulated with a greasy layer to
inhibit corrosion.
This layer has to be removed. You can use standard solvents that do not
damage the machine surface.
N O T I C E
 Do not use solvents based on nitrite, aggressive solvents like
break cleaners or scrubbing agents!
 These damage the machine surface.
Power supply
A T T E N T I O N
When working with non-grounded machines:
Severe injury or even death may arise though electrocution!
Therefore: The machine must be operated at a grounded power
socket
The connection of the machine to the electric power supply and the
following checks have to be carried out by a respectively trained electrician
only.
a. The electronic connection of the machine is designated for operation
with a grounded power socket!
b. The mains supply must be secured with 16A:
c. If the connector plug doesn’t fit or if it is defect, only qualified
electricians may modify or re-new it!