Use and Care Manual

- 13 -
UNPACKING AND CLEANING
1. Remove the woodworking lathe from the box
2. Check all the accessories of the machine tool according to the packing
list.
3. Choose a location for the lathe that is dray, has good lighting and has
enough room to be able to service the lathe on all four sides.
4. To avoid twisting the bed, the lathe's location must be absolutely flat and
level. Bolt the lathe to the stand (if used).
5. Clean all rust protected surfaces using a mild commercial solvent,
kerosene or diesel fuel. Do not use paint thinner, gasoline or lacquer
thinner. These will damage painted surfaces. Cover all cleaned surfaces
with a light film of 20W machine oil.
ASSEMBLY
Delivery content
Please check the product contents immediately after receipt for any
eventual transport damage or missing parts. Claims from transport
damage or missing parts must be placed immediately after initial machine
receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
Workplace requirements
The workplace has to fulfill the requirements.
The ground has to be even, in level and hard. It must be suitable at least to
weight it with double weight per square meter than the machines net
weight.
The chosen workplace must have access to a suitable electric supply net
hat complies with the machines requirements.
Transport
The machine can be transported in package with a forklift.