Use and Care Manual

5
screen will start to open up and the image areas will start washing away leaving
your "stencil."
2. Dry the screen with newspaper or a towel (Do not rib in case the emulsion is
still wet) and leave it to dry off. If the areas do not wash away you may have
overexposed the screen, and you will need to use the "emulsion remover"(not
include in this kit) to clean the screen and start the process over, exposing it for
much less time.
STEP 6: Tape the screen perimeter
(This step would use screen printing frame and masking tape from this kit)
During the printing process, unwanted ink sometimes leaks through the edges of
the frame and seeps onto the substrate. To prevent this, use masking tape to
cover all the inside edges of youro screen to prevent any ink from leaking through.
STEP 7: Printing
(This step would use screen printing frame, screen printing squeegee and wood
sticks from this kit)
1. Place your screen flat onto the fabric that you are preparing to print (if it is a
T-shirt make sure to place a piece of cardboard inside to prevent ink from soaking