Thank you for your selecting our Slush Machine Please read this manual carefully before using to ensure safe and proper operation, and please keep it properly .
Table of Contents 1. Product Description 1.1. Product use 1.2. Main Parts 1.3. Technical Parameters 1.4. Control Panel Description and Function 2. Installation 2.1. Installation Location 2.2. Power Connection 3. Operation 3.1. Materials Preparation 3.2 Start-up 3.3. Slush Concentration Adjustment 3.4. Slush Discharge 3.5. Emergency 4. Operation and Storage 4.1. Packaging 4.2. Transport and Operation 4.3. Storage 5. Cleaning and Maintenance 5.1. Empty the Bowl 5.2. Disassemble the Push Faucet 5.3.
1. Product Description 1.1. Product Usage This machine is suitable for making slush and cold drinks, and the operation of this slush machine must comply with current standards. 1.4Control Panel Description and Function 1.4.1 Panel Diagram: MODEL: X-150 X-150 1.2. Main Parts The main components of the machine are as follows: 1. Bowl lid 2. Bowl 3. Discharge wrench 4. Discharge port 5. Control Panel 6. Chassis 7.
“Add(+)” key to change the value. After 5 seconds without operating the key, the system will exit and save the setting value automatically. 6.Hold down “Subtract(-)” key and “Add(+)” key for 5 seconds at the same time to enter the Factory parameter setting mode, press the “Lighting” key to change the object, press “Subtract(-)” key and “Add(+)” key to change the value. The system will exit and save the parameters automatically after 5 seconds without any operation of keys. ( Model:X-300) 1.
3. The power cord and the plug size shall be in compliance with the parameters on the machine nameplate, properly grounded, and coupled with applicable switches and circuit breakers. Never operate the machine near flammable or explosive objects.
2) Before making slush for the customer, please use a small amount of product to try first. Warning: 1) Please do not open the lid forcibly. 5.5 Emergency Situations 2) Never add liquid higher than 25 degrees Celsius 3) When feeding the bowl, be careful not to exceed the maximum limit and must exceed mixer shaft. 4) Please do not turn on the machine when the lid is not in place. Please turn off and unplug the machine before removing the lid.
container (2% sodium hypochlorite mixed with water) 2. Thoroughly wash the bowl, lid and evaporator with a soaked sponge. 3. Thoroughly clean with water 4. Pour disinfectant into another container 6.4 Disassemble the push handle 1. Put the bowl on a smooth surface to facilitate the removing of the tap. Pull the "U" towards you and push the tap with your other hand. 2. Unlock the spring, hold it down, push horizontally and finally release it. 3. Unscrew the bar from the tap. 4.
Important note: Always check the integrity of the seal ring. If the seal ring is broken, it should be replaced with a new one Use the supplied Vaseline to lubricate the seal ring in the illustrated area.
