Manualshelf

Use and Care Manual

ManualsBrandsVEVOR ManualsBuilding materialsSteel Strapping Tool for 1/2 in.-3/4 in. Width 3-in-1 (Tensioner, Crimper, Cutter) Manual Belt Packaging Banding Machine
12345678910
- 8 -
After every disassembly it is essential to retighten screws A57 and A58 with
the recommended torque when reassembling.The use of a torque key is
necessary.
6. CLEANING
In case of heavy dirt and when painted straps are used the
punch,dies,gripper and feed-wheel must be cleaned regularly.Normally it is
sufficient to blow out the parts with the help of an air gun.
7. ACCESSORIES
Using tool with horizontal handle
Upon request the tool can be supplied with a bolt A84 and a grip ball
A51.When using tool for horizontal applications,the operator holds the tool
on the grip ball during tensioning.
Install the handle as follows:
Remove side cover A44 and break the marked position.Reassemble side
cover and screw bolt with mounted ball into the body