Manualshelf

Use and Care Manual

ManualsBrandsVEVOR ManualsBuilding materialsSteel Strapping Tool for 1/2 in.-3/4 in. Width 3-in-1 (Tensioner, Crimper, Cutter) Manual Belt Packaging Banding Machine
12345678910
- 7 -
must be taken away from the package.The tool must be readjusted
immediately(see SEALADJUSTMENT).
Incorrect seal (the sealing mechanism is adjusted too low)
This stamped seal is too deep and the lower strap is scratched by the
cutter.Although the tensile strength of this seal is sufficient the strapping
must be taken away from the package because of the scratched lower
strap.The tool must be readjusted immediately (see SEALADJUSTMENT).
5. SEAL ADJUSTMENT
The sealing and cutting depth of the sealing mechanism and the cutter can
be adjusted with the use of the hexagon key A83 which is supplied with the
tool as follows:
·Place tool as shown above.
·Loosen both screws A72 open themby approx.3 revolutions.
·If sealing depth is not sufficient reset stop in the direction of the base
plate.
·If sealing depth is excessive reset stop in the direction of the body cover.
·Retighten screws A72.
Assembly Instructions