Instructions / Assembly

- 5 -
4. Replace the lid and turn clockwise to lock into place.
5. Connect the plug to the socket.
6. Switch ON. The Red "Heating" pilot lamp will light up and the wax
starts to heat up.
7. The wax will reach the set thermostat temperature.
8. Stand your cup on the hold close to the faucet to prevent splashing
of wax.
9. Use the faucet to dispense wax.
10.When the wax is topped up the wax melter will automatically reboil.
11.When the wax is completely melted,turn the appliance off and
unplug it from the electric outlet,pour out all the wax.
12.Make sure at least 500ml wax in the tank when heating to prevent
a boil-dry accident.
13.The melter can be very heavy when filled with wax. Melter should
not be carried or moved when full of wax as the weight and
unsteady load can cause injury or strain. Melter should be placed
in their position of use and filled through several trips with a smaller,
manageable container (eg a jug). To ensure operator safety in
lifting the machines, Melter should never be moved when filled with
more than 5L (5L =5Kg approximately).
BOIL DRY PROTECTION
The appliance is protected by a thermal limiter with automatically re-
set function to prevent accidental dry-boil. .If the wax in the tank is
boiled dry , this is activated, the appliance will turn itself off, although
the lamp with remain on. The appliance must be unplugged before
it can be reset. To reset the appliance, wait until the appliance has
cooled down, then power on the appliance again, check if the heating
pilot light is on. If the pilot light is on, it indicates the unit has recovered
to normal working condition; if the light is still off, unplug the cord and
try to power on again. Repeat this operation several times until the
appliance is under normal working condition.
This facility is for the protection of the user as well as the components.
In case of such repeated incidents the bi-metal may malfunction
causing damage of thermal limiter as well as the heating element