Use and Care Manual

2
z To avoid personal injury, please do not modify or weld hydraulic equipment
without approval of .
z Please never lift a more than the rated capacity of the cylinder, overloading
causes equipment failure and serious personal injury.
z The cylinder is a load lifting device, not a load holding device. After the load has
been raised or lowered, it must always be held mechanically, never work under a
load supported by a hydraulic unit.
z Keep hands and feet away from cylinder and workplace during operation to avoid
personal injury.
z Do not put unbalanced or off-center loads on cylinders. The incorrect load can
result in equipment failure and serious personal injury.
WARNING
z Wear safety glasses, helmet and other necessary personal protective equipment
when operating hydraulic equipment.
z Cylinder used to lift load must have solid footing for correct support. Please select
steel or wood blocks that are capable of supporting the load.
z Install Pressure gauges in the system to monitor the operating pressure. The
gauge must have the same pressure rating as the pump and cylinder. The wrong
gauges may result in personal injury.
z The system operating pressure must lower than the lowest rated pressure in the
system.
z Carefully inspect the cylinder and couplers before use cylinder. Never connect the
cylinder with damaged couplers or damaged port threads. The damaged coupler
or damaged port threads may cause equipment failure and possible personal
injury.
z Install coupler in a clean environment; prevent dirt or other debris from entering
into cylinder body or tube. Dirt or other debris will damage the cylinder and result
in equipment failure and possible personal injury.
z Before removing or tightening hose or coupler, release hydraulic pressure in
system.
z Never handle pressurized hoses; escaping oil under high pressure can penetrate
the skin, causing serious injury. Seek medical aid immediately if injured.
z Please use or other approved hydraulic oil
z For hydraulic technical help or repair service. Please contact the authorized Service
Center in your area. has no obligations under any warranty with respect to products
that have been repaired by unauthorized personnel, modified, or damaged through
misuse, abuse, accident, neglect, or mishandling.
IMPORTANT
z Keep the air hydraulic pump clean all the time.
z When the Air hydraulic pump is not in use, release the valve, remove hose and
use rubber cap to recover the port.