Use and Care Manual

ManualsBrandsVEVOR ManualsAutomotiveAir Hydraulic Pump 10000 PSI Air Treadle Foot Actuated 3/8 in. NPT 1/2 Gal. with 6 ft. Hose 2 Connector Single Acting

INSTRUCTION SHEET FOR AIR HYDRAULIC PUMP

Repair Parts Sheets for hydraulic hand pumps are available from your nearest

authorized Service Center or Sales office.

NOTE

PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE AIR

HYDRAULIC PUMP.

Carefully inspect all components for shipping damage, if shipping damage is found.

Please notify carrier at once. The carrier is responsible for any damage resulting from

shipment.

1. SAFETY

To avoid personal injury or property damage, please follow all safety

precautions. cannot be responsible for injury or damage resulting from

unsafe and incorrect products use or system operation, or lack of

maintenance.

DANGER is used when your action or lack of action may cause serious injury or even

death.

WARNING indicates a potential danger that requires correct action to avoid personal

injury.

IMPORTANT indicates correct action to prevent damage or equipment failure.

DANGER

z The hydraulic equipment operator must be a qualified operator familiar with

correct training and work experience of hydraulic equipment. Lack of knowledge

in any of these areas can lead to equipment damage or personal injury.

Summary of content (5 pages)

PAGE 1
INSTRUCTION SHEET FOR AIR HYDRAULIC PUMP Repair Parts Sheets for hydraulic hand pumps are available from your nearest authorized Service Center or Sales office. NOTE PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE AIR HYDRAULIC PUMP. Carefully inspect all components for shipping damage, if shipping damage is found. Please notify carrier at once. The carrier is responsible for any damage resulting from shipment. 1.
PAGE 2
z z z z z To avoid personal injury, please do not modify or weld hydraulic equipment without approval of . Please never lift a more than the rated capacity of the cylinder, overloading causes equipment failure and serious personal injury. The cylinder is a load lifting device, not a load holding device. After the load has been raised or lowered, it must always be held mechanically, never work under a load supported by a hydraulic unit.
PAGE 3
z z z Do not drop objects on hose. Do not lift and carry hydraulic equipment by the hoses or couplers, use the handle or other means. Use hydraulic equipment in normal operating temperatures. Do not use equipment in temperatures of 65 ℃ (150℉) or higher. Overheating will soften seals and weakens hose materials, resulting in oil leaking or other equipment failure. 2. DESCRIPTION Air Hydraulic Pump supplies hydraulic fluid pressure to selected tools. It consists of an in-line air and hydraulic cylinder.
PAGE 4
a. Depress the “Pump” end of pedal will pump hydraulic oil to the system. b. Stop depressing the “Pump” or “Release” end will stop and hold the pressure. c. Depress the “Release” end of pedal will release the pressure in the system. RELEASE PUMP Hydraulic Oil Output Port Air input port 5. MAINTENANCE 5.1 Inspect the connections Please Inspect hoses and connections and tighten connections as needed. Use non-hardening pipe thread compound when servicing connections. 5.
PAGE 5
z z Clean the pump and hose and couplers Store in clean dry environment, avoid temperature extremes. 6. TROUBLE SHOOTING IMPORTANT: hand pumps should be repaired only by a qualified operator or Authorized Service Centers. Repairing hand pumps without special tools and knowledge may result in personal injury. Always release pressure and disconnect hose(s) before making repairs.