Use and Care Manual

Operation Instructions
 Press the switch to turn on the machine and wait 1-2
minutes.Observe whether the machine is running
smoothly when the sugar outlet is spinning.
 Adjust the temperature knob and the Voltmeter will
change with the adjustament.Adjust the voltage
according to the actual needs of users.Let the
machine warm up for 4-5minutes.
 Pour a spoonful of clean granulated sugar into sugar
outlet in the stainless steel pan.
 After about 3 seconds,the marshmallow is sprayed
out.Hold a bamboo stick or other stick-shaped object
and spin it along the inner wall of the receiving plate
several times.Then place the bamboo stick
horizontally and spin it above the turntable in order
to form marshmallow.( Make different shapes of
marshmallows by sloping the bamboo stick.)
 After making enough marshmallow, turn off the
machine.
Cleaning
 The machine needs to be cleaned after making
marshmallow, otherwise the sugar outlet may be
blocked.Keep the machine running during cleaning,
pour a small amount of water into the rotor
slowly,then the rotor will shake off the water.Turn off
the machine and clean it with a dry soft cloth.
 If the rotor is blocked,keep the machine off,open
turntable and clean the burnt sugar in it.
 Do not clean the machine with detergent.
 Do not rinse the machine with water directly.
4
Note
 Do not let children use the machine.
 Use grounded socket.Do not place the wire close to
the hot surface.Do not immerse the wire,lug or
machine in water or other liquids. Do not use the
damaged wire,socket or plug.
 Install the machine Correctly than insert the plug into
the socket.After finishing using the machine,turn off
it,then Unplug.
 Do not touch the Spinning sugar outlet or the hot
surface when the machine is working.Do not put your
hand into the pan before the suger is used up.
 Do not move the machine when it is working.
 Avoid long continuous work.After an hour of
continuous work, pause for twenty minutes.
 Do not let the machine run without load for a long
time.
 Do not touch the plug or wire with wet hands.
 Do not touch the plug or wire if it’s wet