Use and Care Manual

- 8 -
8. If this product is allowed to boil dry, a thermostat will automatically cycle the
element off and on to prevent the kettle from overheating. If this situation
occurs, unplug the kettle and let it cool before refilling to the proper level.
NOTE: If the product is allowed to boil dry, the buttons and lights on the control
panel will not operate until the product cools down.
til the product cools down.
CLEANING YOUR DISPENSING KETTLE/
INSTANT HOT WATER HEATER
Disconnect the product from the wall socket before cleaning. Unplug the cord from
the appliance and allow the unit to cool to room temperature. Pour out the
remaining water. Remove the top lid as follows: lift top lid to about a 45° angle,
press the “lid release” button located at the rear of the top cover and pull upwards
at 45° angle.
CAUTION: Water may still be hot and hot vapour may escape
The exterior of the product and its inner pot should be cleaned by using a damp
cloth. Do not use abrasive cleaners as they can result in scratched surfaces.
CAUTION: Do not immerse the product in water or any other liquid as this could
cause the unit to become unsafe. Do not place the unit upside down to dry it.
Mineral deposits may form a coating on the inner pot, which will cause the kettle to
take longer to boil. Cleaning must be done regularly.