Use and Care Manual

- 7 -
Caution: If the dispense button is not selected within 10 seconds after
selecting the unlock button, the appliance will automatically revert back to
the lock position. The auto dispensing function will not operate if the
product is not connected to power.
Note: The unlock button is a safety feature meant to prevent accidental
dispensing of hot water from the product through the pressing of a single
button.
● MANUAL DISPENSING. (SABBATH MODE) On the upper lid, switch the
pump lock to the “unlock” position. Then push the “water pump lid” to dispense
some water. Allow the pump lid to return to its default position and repeat if
more water is required.
Note: Manual dispensing can be performed even when the product is not
connected to power. However, without power, the product will not be
able to keep the water at the desired keep-warm temperature indefinitely.
● CUP SWITCH. In the front panel, press the “unlock” button once. The
yellow UNLOCK indicator light will come on. While holding a cup under the
water outlet, push the cup up against the cup switch under the upper lid to
dispense water. The product will automatically dispense water from the water
outlet while the cup switch is pressed.
● Caution: If the cup switch is not pressed within 10 seconds after selecting
the unlock button, the appliance will automatically revert back to the lock
position. The cup switch function will not operate if the product is not
connected to power.
7. After the desired keep-warm temperature is reached, the product will maintain
this temperature. To reboil the water at any time, press “reboil” button once.
The green keep-warm light will turn off and the boil indicator light will come on.
After reboil has been completed, the keep warm indicator light will turn on
again.
CAUTION: Reboil will not function if there is insufficient water inside.
Pressing the reboil button immediately after the water has just reached the
boiling level will also have no effect as the water is already at 100°C.