Use and Care Manual

- 4 -
defrosting process, other than those recommended by the manufacturer.
16. Do not damage the refrigerant circuit.
CAUTION
1. This unit must be properly installed in accordance with the installation
instructions along with all local codes before it is used. See grounding
instructions in the Installation section.
2. This model can either be built-in or free-standing. Built-in units vent at
the bottom front and airflow at the front of this vent must be unimpeded.
3. Install the unit in a location where the floor is sturdy enough to support
the load of the unit. If the floor is not sturdy enough or installation is
incorrectly performed, the unit could tip over and cause personal injury. If
the unit is placed on a stand, the front surface must be 3” or more back
from the edge of the stand in order to avoid accidental tipping of the
appliance during normal usage.
4. Never place heavy objects or items containing water on top of the unit.
Objects could fall and cause injury and spilled water could cause the
deterioration of the insulation of electrical components and result in
electrical shock.
5. Disconnect the unit if it is behaving abnormally, and do not reconnect
until the situation is corrected.
6. Pull out the plug before doing any maintenance on the unit to avoid
electric shock.
7. Never pull out plug when hands are wet!
8. This unit is not intended for the storage of medicines or chemical
reagents.
9. Keep packing materials away from children.
10. Condenser water from evaporator drains into a hole in the floor of the
storage compartment and is channeled into a drain pan located at the back
of the unit on the compressor. Heat transferred from the compressor