Use and Care Manual

- 15 -
temperature displayed by the electronic control panel is the instantaneous
average temperature of the unit and there may be a variation of
approximately 0 to 6 Fahrenheit degrees.
When fully loaded with room temperature product, the unit will operate
continuously for as long as 24 hours to reduce the temperature inside the
cabinet to the desired point. Under normal conditions, when the unit has
been on for six hours, it will stop working for about thirty minutes to defrost
automatically.
The unit is designed to operate between 50°F (10℃) and 100°F (38℃).
Higher ambient temperatures may reduce the unit’s ability to reach low
temperatures. Best results are obtained at temperatures between 65°F
and 80°F for built-in models and between 65°F and 90°F for freestanding
models.
Caution: Damages caused by ambient temperatures of 40°F (4℃) or
below are not covered by the warranty.
To temporarily stop the cooling cycle, unplug the Refrigerator. To shut it
down for longer periods of time, disconnect the plug and leave the door
partially open.
NOTE: If you unplug the Refrigerator, allow 3 minutes before plugging it
back in. The unit will not restart in less than 3 minutes.
Memorized Temperature Settings
Your unit has been designed to “remember” the last run mode to which it
was set. If there is a power outage or any other power cutoff, the unit will
automatically return to the previous temperature setting after the power
has returned.
Compressor Run Indicator
When the compressor is running, the control panel will light a running LED
light representing a running compressor. If the compressor stops running,
the running LED will go out as well.