Use and Care Manual

CARE AND MAINTENANCE

If the pump will not run, try the following solutions:

• Ensure that the intake screen is free of obstruction.

• Make sure that the water hose isn’t clogged or knotted.

• Be sure the unit is plugged into a functioning power outlet.

• Be sure there is adequate water in the water tray.

Note: To prevent accidental starting, do not handle the pump while it is connected to a power source.

Brush Replacement

The saw has externally accessible brush assemblies that

should be periodically checked for wear.

Proceed as follows when replacement is required:

• Unplug the saw.

• Remove brush cap with a flat head screwdriver (not

included). Brush assembly is spring loaded and will pop

out when you remove brush cap.

• Remove brush assembly.

• Check for wear. Replace both brushes when either has

less than 1/4 in. length of carbon remaining. DO NOT

replace one side without replacing the order.

• Reassemble using new brush assemblies (not included).

Make sure curvature of brush matches curvature of motor

and that brush moves freely in brush tube.

• Make sure brush cap is oriented correctly (straight) and

replace.

• Tighten brush cap securely. Do not overtighten.

Brush AssemblyBrush Assembly

Brush Cap