Use and Care Manual

OPERATING INSTRUCTIONS

To square the cutting wheel to the table

Do not loosen any nuts for this adjustment until you have

checked with a square and made test cuts to be sure

adjustments are necessary. Once the nuts are loosened,

these items must be retightened.

• Unplug the saw.

• Using the 3mm hex wrench (not included) and 8 mm hex

wrench (included),loosen cap screws on the motorhead

assembly.

• Place a framing square against the fence and the flat part

of the wheel.

• Using the 24 mm wrench (not included), turn the studs

toadjust the position of the motor head assembly until the

fence is square with the cutting wheel.

• Move sliding table through full range of travel, to check

for square. Make adjustments again, if necessary.

• Visually check that blade is centered in 0˚ slot.

• After all necessary adjustments have been made tighten

the nuts and cap screws securely.

Tool storage

• This saw provides a convenient storage for arbor wrench

and hex wrench on the back of motor head assembly.

• When not in use, the power cord could be wrapped on the

two hooks on the back of motor head assembly.

Framing

square

Framing

square

Cap screw

Stud

Cap screw