Use and Care Manual

OPERATING INSTRUCTIONS

Adjustments

WARNING

Before performing any adjustment, make sure the tool is unplugged from the power supply and the

switch is in the OFF position. Failure to heed this warning could result in serious personal injury.

Depth Stop Adjustment

The depth stop limits the wheel’s downward travel. It allows

the wheel to go below the table enough to maintain full

cutting capacities. The depth stop is factory set to provide

maximum cutting capacity for the wheel provided with the

saw. Make adjustment if needed.

• Unplug the saw.

• To adjust the depth, loosen the wing nut located on the

depth stop knob.

• Turn the depth stop knob. Set the wheel to the correct

cutting depth (wheel just below the table surface).

Lower the cutting wheel to the table to check the wheel

clearance.

• Tighten the wing nut.

Bevel Adjustment

Slide the table clear of the blade to prevent blade damage.

• Loosen the bevel lock lever.

• Adjust the motor head to the desired angle: 0°, 22.5° and

45°. Do not set bevel to other settings. The slots on the

table are designed only for these cuts.

• Tighten the bevel lock lever.

Note: If the bevel lock lever isn’t in the desired position

when locked, you can pull the bevel lock lever out, rotate

to desired position, then release back.