Manualshelf

Use and Care Manual

ManualsBrandsVEVOR ManualsFlooringWet Tile Saw, 15-Amps 10 in. 65Mn Corded Wet Tile Saw, 4500 RPM, Tile Cutter Wet Saw with Water Reservoir and Casters
31323334353637383940
28
1
1
2
Locking Saw
With the saw turned OFF, install a padlock (not included)
through the hole in the switch.
WARNING
• In the event of a power failure or when the tool is not in
use, turn the switch OFF. This action will prevent the tool
from accidentally starting when power returns.
• ALWAYS make sure your workpiece is not in contact with
the cutting wheel before operating the switch to start the
tool. Failure to heed this warning may cause the workpiece
to be kicked back toward the operator and result in serious
personal injury.
• To reduce the risk of accidental starting, ALWAYS make
sure the switch is in the OFF position before plugging tool
into the power source.
Locking the Sliding Table
• Sliding the sliding table and align the lock pin with the
sliding table end.
• Turn the sliding table lock knob (K) counter-clockwise to
horizontal position to lock the sliding table (I).
OPERATING INSTRUCTIONS
I
K
Lock pinLock pin
LOCKED
LOCKED